Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > copy host-affinity
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED
P2X0-1030-09ENZ0
276
copy host-affinity
This command copies the mapping definition from one specified host interface port to another host interface
port. This command cannot be used when Host Affinity Mode is disabled for the host interface port.
■
Syntax
■
Parameter
■
Example(s)
copy host-affinity -source-port {
xyz
} -destination-port {
xyz
|all}
-source-port This parameter specifies the host interface port of the copy source. Only one parameter can be
specified at the same time.
Example-source-port 000
For details, refer to
"1.2.14 Host Interface Port Syntax" (page 25)
.
xyz
"x" is the controller module (CM) number, "y" is the CA number, and "z" is the host port
number.
Example: "123" indicates CM#1-CA#2-Host port#3
-destination-port
This parameter specifies the host interface ports of the copy destination. Two or more
parameters can be specified by separating them with a comma.
Example: -destination-port 000,100
For details, refer to
"1.2.14 Host Interface Port Syntax" (page 25)
.
If "all" is selected, all of the host interface ports will be changed.
xyz
"x" is the controller module (CM) number, "y" is the CA number, and "z" is the host port
number.
Example: "123" indicates CM#1-CA#2-Host port#3
all
All the ports with the same type as the port that is specified using the "-source-port"
parameter.
The following example copies the host affinity definition from host interface CA#0 Port #0 on CM#0 to host
interface CA#0 Port #0 on CM#1:
CLI> copy host-affinity -source-port 000 -destination-port 100
The following example copies the host affinity definition from host interface CA#0 Port #0 on CM#0 to all the
host interface ports:
CLI> copy host-affinity -source-port 000 -destination-port all
Summary of Contents for Eternus DX410 S2
Page 2: ...This page is intentionally left blank ...
Page 756: ......