Fujitsu Eternus DX410 S2, Cli User'S Manual

Page: 196 / 756

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set fc-parameters
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
196
set fc-parameters
This command sets up the parameters to control each Fibre Channel (FC) host interface port. Host Affinity
Mode can be changed by using this command.
For a change of host port mode, refer to the "set host-port-mode" command.
■ Syntax
■ Parameter
set fc-parameters -port {
xyz
|all }
[-host-affinity {enable | disable}] [-connect {loop | fabric}]
[-rate {auto|1g|2g|4g|8g|16g}]
[-loop-id-assign {auto-ascending | auto-descending | manual}]
[-loop-id
loop_id
] [-frame-size {512|1024|2048}]
[-host-response-number
host_response_number
| -host-response-name
host_response_name
]
[-reset-scope {initiator-lun | target-lun}] [-reserve-cancel {enable | disable}]
[-rec-line-no
rec_line_no
]
[-rec-transfer-sync {enable|disable}]
[-rec-transfer-stack {enable|disable}]
[-rec-transfer-consistency {enable|disable}]
[-rec-transfer-through {enable|disable}]
-port This parameter specifies the FC interface port number to be set up. Two or more parameters
can be specified by separating them with a comma.
Example: -port 000,110
For details, refer to
"1.2.14 Host Interface Port Syntax" (page 25) .
xyz "x" is the controller module (CM) number, "y" is the CA number, and "z" is the FC port
number.
Example: "123" indicates CM#1-CA#2-Port#3
all All FC interface ports
-host-affinity
Optional. This parameter specifies the Host Affinity Mode. If omitted, the existing setting is not
changed.
The host affinity is the security capability of the system against host servers. The access from
hosts can be limited by enabling Host Affinity Mode. If the RA mode or Initiator mode is being
set for the specified ports, this parameter cannot be specified.
enable Host Affinity Mode is enabled.
disable Host Affinity Mode is disabled.
-connect Optional. This parameter specifies the connection condition of the FC port. If omitted, the
existing setting is not changed. The default value is a loop (FC-AL) connection.
Specify "fabric" for 16Gbit/s direct connections.