Fujitsu Eternus DX410 S2, Cli User'S Manual

Page: 243 / 756

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set host-iscsi-name
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
243
set host-iscsi-name
This command changes the details of an existing iSCSI host.
■ Syntax
■ Parameter
set host-iscsi-name {-host-number
host_number
| -host-name
host_name
} [-iscsi-name
iscsi_name
]
[-alias-name
alias_name
] [-ip-version {ipv4|ipv6}] [-ip
ip_address
] [-name
name
]
[-chap-user
chap_user
]
[-host-response-number
host_response_number
| -host-response-name
host_response_name
]
[-cmdsn-count {unlimited | 20 | 40 | 80 | 120 | 180}]
-host-number
or
-host-name
This parameter specifies the identifier of the host whose details are to be changed. If only the
host response identifier is being set, then one or more identifiers can be specified at the same
time. If not, then only one host identifier can be specified. For details, refer to
"1.2.10 Host
Syntax" (page 23) .
-iscsi-name Optional. This parameter specifies the iSCSI name that corresponds to an HBA. Between 4 and
223 alphanumerical characters, including hyphens (-), dots (.), and colons (:), can be used. If
omitted, the existing setting is not changed. Only one name can be specified at the same
time.
-alias-name Optional. This parameter specifies an alias to the iSCSI name that corresponds to the "-iscsi-
name" parameter. A maximum of 31 alphanumeric characters can be used. Usable characters
are those given in the
"1.2.2 Keywords and Parameters" (page 19) of the document overview.
Commas (,) cannot be used. If omitted, the existing setting is not changed. Only one name can
be specified at the same time.
This name is not used for control purposes. It is only handled as a comment corresponding to
the iSCSI name.
-ip-version Optional. This parameter specifies the format of the IP address after the setting change. If this
parameter is omitted, the existing setting is not changed. If this parameter is omitted and the
"-ip" parameter is specified, a parameter value that corresponds to the format of the IP address
that is specified for the "-ip" parameter is specified.
ipv4 IPv4 format
ipv6 IPv6 format