Fujitsu Eternus DX410 S2, Cli User'S Manual

Page: 220 / 756

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set fcoe-parameters
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
220
set fcoe-parameters
This command sets up the parameters to control each Fibre Channel over Ethernet (FCoE) host interface port.
Host Affinity Mode can be changed by using this command.
■ Syntax
■ Parameter
set fcoe-parameters -port {
xyz
|all } [-host-affinity {enable|disable}] [-rate {10g}]
[-frame-size {512|1024|2048}] [-host-response-number
host_response_number
|
-host-response-name
host_response_name
] [-reset-scope {initiator-lun | target-lun}]
[-reserve-cancel {enable | disable}] [-fcf-vlan-id {enable | disable}] [-fcf-vlan-id-value {0 - 4095}]
[-fcf-fabric-name {enable | disable}] [-fcf-fabric-name-value
WWN
]
-port This parameter specifies the FCoE interface port number to be set up. Two or more parameters
can be specified by separating them with a comma.
Example: -port 000,110
For details, refer to
"1.2.14 Host Interface Port Syntax" (page 25) .
xyz "x" is the controller module (CM) number, "y" is the CA number, and "z" is the FCoE port
number.
Example: "123" indicates CM#1-CA#2-Port#3
all All the FCoE interface ports
-host-affinity
Optional. This parameter specifies the Host Affinity Mode. If omitted, the existing setting is not
changed.
The host affinity is the security capability of the system against host servers. By enabling Host
Affinity Mode, it can limit the access from hosts. If the Initiator mode is being set for the
specified ports, this parameter cannot be specified.
enable Host Affinity Mode is enabled.
disable Host Affinity Mode is disabled.
-rate Optional. This parameter specifies the FC transfer rate. If omitted, the existing setting is not
changed.
10g 10Gbit/s
-frame-size Optional. This parameter specifies the FC frame size. If omitted, the existing setting is not
changed. If the RA mode or Initiator mode is being set for the specified ports, this parameter
cannot be specified.
512 512 byte.
1024 1024 byte.
2048 2048 byte.