Fujitsu Eternus DX410 S2, Cli User'S Manual

Page: 452 / 756

Chapter 4 Function/System Settings and Display
4.3 Network Management > set network
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
452
set network
This command sets up parameters for the Ethernet network, and checks the consistency of parameters. If the
system detects an inconsistency between the parameters, the command is terminated abnormally.
• An IP address can be deleted by specifying it as "0.0.0.0".
• An IP address that is used for connection to the MNT port on the master controller module (CM) cannot be
deleted.
• When critical changes are made (such as changing a subnet address), all of the network parameters
should be reconfigured.
• When a network change means that the connection cannot be maintained, the user is logged off
automatically.
• When "fst" is specified for "-port", gateway, DNSs and IP addresses cannot be set.
■ Syntax
■ Parameter
set network -port {maintenance | remote | fst} [-ip-format {v4|v6}] [-ipv6-set-auto {disable|enable}]
[-master-ip
ip_address
] [-slave-ip
ip_address
] [-master-link-local-ip
ip_address
]
[-slave -link-local-ip
ip_address
] [-master-connect-ip
ip_address
] [-slave-connect-ip
ip_address
]
[-netmask
netmask
] [-subnet-prefix-length
length
] [-gateway
gateway
]
[-allow-ip1
ip_address
,
netmask
] [-allow-ip2
ip_address
,
netmask
] [-allow-ip3
ip_address
,
netmask
]
[-allow-ip4
ip_address
,
netmask
] [-allow-ip5
ip_address
,
netmask
] [-allow-ip6
ip_address
,
netmask
]
[-allow-ip7
ip_address
,
netmask
] [-allow-ip8
ip_address
,
netmask
] [-allow-ip9
ip_address
,
netmask
]
[-allow-ip10
ip_address
,
netmask
] [-allow-ip11
ip_address
,
netmask
] [-allow-ip12
ip_address
,
netmask
]
[-allow-ip13
ip_address
,
netmask
] [-allow-ip14
ip_address
,
netmask
] [-allow-ip15
ip_address
,
netmask
]
[-allow-ip16
ip_address
,
netmask
] [-speed {1000|100full|100half|10full|10half|auto}]
[-primary-dns-ip
ip_address
] [-secondary-dns-ip
ip_address
] [-wake-on-lan {enable|disable}]
-port This parameter specifies the Ethernet port.
maintenance
maintenance port (MNT port)
remote remote port (RMT port)
fst FST port (only for the ETERNUS DX410 S2/DX440 S2 and ETERNUS DX8100 S2/
DX8700 S2)
"fst" is not supported in the ETERNUS DX80 S2/DX90 S2.
-ip-format Optional. This parameter specifies the format of the IP address that is to be set. If omitted, IPv4
is selected. This parameter can be specified when "maintenance" or "remote" is specified for
the "-port" parameter.
v4 The IPv4 setting is performed.
v6 The IPv6 setting is performed.