Fujitsu Eternus DX410 S2, Cli User'S Manual

Page: 233 / 756

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > create host-sas-address
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
233
create host-sas-address
This command registers a host alias for the SAS (Serial Attached SCSI) address that is used to identify a SAS
type HBA (Host Bus Adapter). This alias can then be used instead of a numeric SAS address when mapping
volumes to hosts.
Only one SAS address can be specified at any given time. The maximum number of available definitions
depends on the number of available host interface ports and the model.
■ Syntax
■ Parameter
■ Example(s)
create host-sas-address -address
address
-name
name
[-host-response-number
host_response_number
| -host-response-name
host_response_name
]
[-host-group-number
host_group_number
| -host-group-name
host_group_name
|
-new-host-group-name
new_host_group_name
]
-address This parameter specifies the SAS address, which is a 16 character hexadecimal number that
corresponds to a HBA.
Example: -address 500605b000b5f344
-name This parameter specifies the SAS address alias. For details, refer to "1.2.4 Alias Name Syntax"
(page 20) .
-host-response-number
or
-host-response-name
Optional. This parameter specifies a host response identifier. Only one identifier can be
specified at any given time. For details, refer to
"1.2.12 Host Response Syntax" (page 24) . If
omitted, the existing setting is not changed.
-host-group-number
or
-host-group-name
Optional. This parameter specifies the host group identifier. The "-host-group-number" or the
"-host-group-name" parameter must be specified. Only one host group can be specified at the
same time. For details, refer to
"1.2.16 Host Group Syntax" (page 26) .
-new-host-group-name
Optional. This parameter specifies a new host group name. Only one host group can be
specified at the same time. For details, refer to
"1.2.16 Host Group Syntax" (page 26) .
The following example registers the alias "HBA1" for the HBA with SAS address "500605b000b5f344":
CLI> create host-sas-address -address 500605b000b5f344 -name HBA1