Fujitsu Eternus DX410 S2, Cli User'S Manual

Page: 24 / 756

Chapter 1 Overview
1.2 The Command Syntax
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
24
1.2.11 Affinity Group Syntax
There are two methods to specify an affinity group identifier; an affinity group number or an affinity group
name.
• Affinity group number
An affinity group number is automatically created by the system when an affinity group is created. This is a
decimal number. Affinity group numbers can be displayed by using the "show affinity-groups" command.
Affinity group numbers can be combined as follows:
- A single affinity group number: 1
- A list of affinity group numbers: 2,8
- A hyphenated range of affinity group numbers from a to z: 2-5
- A list of affinity group numbers, affinity group ranges, or both, separated by commas. Spaces are not
permitted before or after commas: 1,3,10-12
• Affinity group name
An affinity group name must be specified when creating an affinity group. For details about the syntax,
refer to
"1.2.4 Alias Name Syntax" (page 20) . Some commands accept a comma-separated list of affinity
group names. An affinity group name and an affinity group number cannot both be specified in the same
command. Do not include spaces before or after commas.
1.2.12 Host Response Syntax
There are two methods to specify a host response identifier; a host response number or a host response name.
• Host response number
The host response number can be assigned by the user. This is a decimal number. A host response number
of "#0" is the system default and it cannot be assigned by the user. However, the parameters for host
response #0 can be changed. Host response settings can be displayed by using the "show host-response"
command.
Host response numbers may be combined as follows:
- A single host response number: 1
- A list of host response numbers: 2,5
- A hyphenated range of host response numbers from a to z: 2-5
- A list of host response numbers, host response ranges, or both, separated by commas. Spaces are not
permitted before or after commas: 1,3,10-12
In GUI, "LUN group number" and "LUN group name" is respectively displayed instead of "affinity group
number" and "affinity group name".
Two or more parameters might not be able to be specified for several commands. For details, refer to the
command descriptions.