Chapter 4 Function/System Settings and Display
4.3 Network Management > set network
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED
P2X0-1030-09ENZ0
457
■
Example(s)
The following example sets up network parameters for the Maintenance port (MNT port). The IP address is
"192.168.1.100", and the subnet mask is "255.255.255.0":
CLI> set network -port maintenance -master-ip 192.168.1.100 -netmask 255.255.255.0
The following example sets up network parameters for the Maintenance port (MNT port). The IP address is
"10.10.10.1", the subnet mask is "255.255.0.0", and the gateway address is "10.10.10.250"; accessible
terminals are all addresses on the "10.11.0.0" network, and the single host address "192.168.1.1":
CLI> set network -port maintenance -master-ip 10.10.10.1 -netmask 255.255.0.0 -gateway 10.10.10.250 -allow-
ip1 10.11.0.0,255.255.0.0 -allow-ip2 192.168.1.1
The following example changes the Ethernet speed of the maintenance port (MNT port) to 100Mbit/s full-
duplex:
CLI> set network -port maintenance -speed 100full
The following example sets the IP address in IPv6 address format:
CLI> set network -port maintenance -ip-format v6 -ipv6-set-auto disable -master-link-local-ip
fe80:10:20:34:ab::55:234:abde -slave-link-local-ip fe80:20:31:abcf:f3f::78:4fa -master-connect-ip
2010:df:90a::55:33:234 -slave-connect-ip 2011:23:ab:345:77::32:12a -subnet-prefix-length 64 -gateway
2010:df:90a::52:ab:d3e -allow-ip1 2001:ab:df:23f::abc:56:2 -allow-ip2 2001:234::,64 -primary-dns-ip
2011:ab:def:190::900:32:a80 -secondary-dns-ip 2011:91:aa9::7ab:74:dd
The following example automatically sets the IP address in IPv6 format:
CLI> set network -port maintenance -ip-format v6 -ipv6-set-auto enable
Summary of Contents for Eternus DX410 S2
Page 2: ...This page is intentionally left blank ...
Page 756: ......