Fujitsu Eternus DX410 S2, Cli User'S Manual

Page: 33 / 756

Chapter 2 Status Display
2.1 Storage System Status > show status
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
33
show status
This command displays a summary of the system status. It will display if any components in the system are in
an error or warning condition. It does not indicate if host servers are able to access the system.
■ Syntax
■ Parameters
No parameters.
■ Output
■ Example(s)
show status
Summary status
Summary of the system status.
Empty The ETERNUS DX Disk storage system is not defined or installed.
Normal The ETERNUS DX Disk storage system is in normal state.
Pinned Data PIN data exists in the ETERNUS DX Disk storage system.
Unused
An undefined component is installed in the ETERNUS DX Disk storage system.
Warning A component that is the target for preventive maintenance exists in the ETERNUS DX Disk
storage system.
Maintenance Maintenance is currently being performed on the ETERNUS DX Disk storage system.
Error
A component with an error exists in the ETERNUS DX Disk storage system.
Loop Down The ETERNUS DX Disk storage system is in BackEnd Down state.
Not Ready "Not Ready" is a status where an abnormality is detected at a power-off, and I/O access
from the host cannot be received.
Subsystem Down
The ETERNUS DX Disk storage system is not available.
Change Assigned CM
Hot expansion and recovery of the controller is required.
The following example displays a summary of the system status:
CLI> show status
Summary Status [Normal]
CLI> show status
Summary Status [Error]
CLI> show status
Summary Status [Warning]