Chapter 4 Function/System Settings and Display
4.3 Network Management > set network
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED
P2X0-1030-09ENZ0
453
-ipv6-set-auto
Optional. When "enable" is selected, the link local IP address, the connect IP address, and
gateway are set automatically. If omitted, it is handled as if "disable" is selected. This parame-
ter can only be specified when "v6" is specified for the "-ip-format" parameter.
enable
IPv6 automatic setting is performed.
disable
IPv6 automatic setting is not performed.
-master-ip
Optional. This parameter specifies the IP address of the master CM. The format is IPv4 standard
notation (a base 256 "d.d.d.d" string). If omitted, the existing setting is not changed. This
parameter can only be specified when "v4" is specified for the "-ip-format" parameter.
Example: -master-ip 192.168.1.1
•
If the slave IP address is active, both master/slave IP addresses must belong to the same
subnet address.
•
When "0.0.0.0" is set, the IPv4 settings for the port are disabled.
•
When both IPv4 and IPv6 settings are disabled, the port becomes disabled. (This does not
apply to the ETERNUS DX80 S2/DX90 S2. Both the maintenance port and the remote port
must be enabled for the ETERNUS DX410 S2/DX440 S2.)
-slave-ip
Optional. This parameter specifies the IP address of the slave CM. The format is IPv4 standard
notation (a base 256 "d.d.d.d" string). This parameter cannot be specified for a single-
controller type. If omitted, the existing setting is not changed. This parameter can only be
specified when "v4" is specified for the "-ip-format" parameter.
Example: -slave-ip 192.168.1.2
Both the master/slave IP addresses must belong to the same subnet address.
-master-link-local-ip
Optional. This parameter specifies the link local IP address of the master IP. If omitted, the
existing setting is not changed. This parameter can only be specified when "v6" is specified for
the "-ip-format" parameter and "disable" is specified for the "-ipv6-set-auto" parameter.
Example: -master-link-local-ip fe80::9abd:2df
•
When "0" is set, the IPv6 settings for the port are disabled.
•
When both IPv4 and IPv6 settings are disabled, the port becomes unavailable. (This does not
apply to the ETERNUS DX80 S2/DX90 S2. Both the maintenance port and the remote port
must be enabled for the ETERNUS DX410 S2/DX440 S2.)
Summary of Contents for Eternus DX410 S2
Page 2: ...This page is intentionally left blank ...
Page 756: ......