Fujitsu Eternus DX410 S2, Cli User'S Manual

Page: 391 / 756

Chapter 4 Function/System Settings and Display
4.2 Advanced Copy Management > set advanced-copy-parameters
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
391
set advanced-copy-parameters
This command sets up parameters to use the Advanced Copy functions.
■ Syntax
■ Parameter
set advanced-copy-parameters [-resolution {1|2|4|8|16}] [-table-size
table_size
] [-sdpe {1g|2g|4g}]
[-ec-opc-priority {auto|very-low|low|middle|high|low}] [-warning
warning_level
]
[-copy-schedule-mode {session-balancing|dst-rg-balancing}]
-resolution Optional. This parameter specifies the Advanced Copy resolution. If omitted, the existing
setting is not changed.
1

1 (default)
2

2
4

4
8

8
16

16
-table-size Optional. This parameter specifies the Advanced Copy table size. The size can be specified in
multiples of 8MB. Note that the maximum value depends on the memory size that is to be
installed in the controllers. The initial value is set to 0MB. If omitted, the existing setting is not
changed.
The maximum Advanced Copy table size for each model are shown below:
ETERNUS DX80 S2/DX90 S2: 0 to 256MB
ETERNUS DX410 S2: 0 to 512MB
ETERNUS DX440 S2: 0 to 4096MB
ETERNUS DX8100 S2: 0 to 1024MB
ETERNUS DX8700 S2: 0 to 12288MB
-sdpe Optional. This parameter specifies the resolution for the SDPV. The initial value is set to 1GB. If
omitted, the existing setting is not changed.
1g 1GB (default)
2g 2GB
4g 4GB