Fuji Xerox ApeosPort-V 4020, Administrator'S Manual

Page: 386 / 611

14 Problem Solving
386
Pro
b
lem
Solvi
n
g
14
Network-related Problems
This section describes how to resolve network related problems.
When you cannot communicate with other SMB machines
When using TCP/IP
The possible causes, check points, and remedies when using TCP/IP (LPD) are as follows.
Windows Vista, Windows 7, Windows 8, Windows 8.1, Windows Server 2003, Windows
Server 2008, Windows Server 2008 R2, Windows Server 2012, or Windows Server 2012 R2.
„
When you cannot print
Cause Check point Remedy
If [Auto Master Mode] of SMB
is set to [On], the number of
machines whose information
can be stored is limited. The
number depends on the
network environment. The machine or other SMB
machines cannot be searched
from the Network Computers
icon. Confirm the setting of
[AutoMaster Mode] of SMB. If
the setting is enabled, change
it to [Off].
Cause Check point Remedy
The IP address is incorrect. Request your network
administrator to check the
machine's IP address. Set a correct IP address on the
machine.
The volume of the print data
sent in an instruction from a
computer exceeded the
maximum receivable volume
when the LPD spool is set to
memory spool. Confirm the memory amount
for the LPD spool and the
volume of the print data
transmitted by an instruction. If the one file of print data
exceeds the memory amount,
divide the file not to exceed the
amount.
If the print data is divided into
multiple files and exceeds the
memory amount, decrease the
number of files not to exceed
the amount.
An unrecoverable error
occurred during the printing
process. Confirm whether any error
messages are displayed on the
control panel. Restart the machine. Wait until
the screen completely goes out
to switch on the machine
power.
The machine is not set to the
transport protocol
corresponding to the computer. Confirm the transport protocol
selected on the machine. Select the transport protocol
corresponding to the computer.
The machine is trying to
process a data format that
does not match the data
format of the print data
transmitted from a computer.
-
Set not to output Ctrl-D.