Fayat Group Bomag MPH 122-2, Operating & Maintenance Instructions, Page: 180 / 198

As required
BOMAG 180 MPH 122-2
!
Danger
Wear goggles and gloves when changing the
cutting tools. Injury by hard metal splinters!
l
Knock damaged or worn cutting teeth out of
holder (1) (Fig. 366).
l
Knock new cutting teeth with bearing shell into
the holder until they bottom and check whether
the cutting tooth can rotate freely.
Fig. 367
l
Check the seat area of the round shank tooth
holder with the male gauge BOMAG-No. 591
701 38 (Fig. 367).
!
Caution
If the seat area is at one point smaller than the
large diameter of the male gauge have a new
holder assembled using the special tool kit
BOMAG-No. 590 020 23.
Fig. 368
!
Caution
Always switch the main battery switch (Fig.
368) to position "0" before starting welding
work on rotor or machine.
Disconnect the batteries and connect negative
and positive cables. Pull the plugs of ESX-con-
trol and Dios-module (water injection).
Fig. 369
l
Turn the rotary switch for free-wheeling of ro-
tor (a) (Fig. 369) back to position "Left".
l
Raise the rotor to highest position.
l
Unhook the safety chain.