Fayat Group Bomag MPH 122-2, Operating & Maintenance Instructions, Page: 15 / 198

Safety regulations
BOMAG 15 MPH 122-2
Regular safety inspections
Have the machine inspected by an expert (capa-
ble person) as required for the conditiosn the ma-
chine is working under, but at least once every
year.
Who is allowed to operate the ma-
chine?
Only trained, instructed and authorized persons of
at least 18 years of age are permitted to drive and
operate this machine. For operation of the ma-
chine the responsibilities must be clearly specified
and complied with.
Persons under the influence of alcohol, medicine
or drugs are not allowed to operate, service or re-
pair the machine.
Maintenance and repair work requires specific
knowledge and must therefore only be performed
by trained specialists.
Conversions and alterations to the ma-
chine
Unauthorized conversions to the machine are pro-
hibited for safety reasons.
Original parts and accessories have been special-
ly designed for this machine. We wish to make ex-
pressly clear that we have not tested or authorized
any original parts or special equipment not sup-
plied by us. The installation and/or use of such
products can impair the active and/or passive driv-
ing safety. The manufacturer expressly excludes
any liability for damage resulting from the use of
non-original parts or accessories.
Damage, deficiencies, misuse of safety
installations
Machines which are not safe to operate or in traffic
must be immediately taken out of service and shall
not be used, until these deficiencies have been
properly rectified.
Safety installations and switches must neither be
removed nor must they be made ineffective.
Safety notes in the operating and main-
tenance instructions:
!
Danger
Sections marked like this point out possible
dangers for persons.
!
Caution
Sections marked like this point out possible
dangers for the machine or for parts of the ma-
chine.
i
Note
Sections marked like this provide technical infor-
mation concerning the optimal economical use of
the machine.
Environment
Sections marked like this highlight activities
for the safe and environmental disposal of fu-
els and lubricants as well as replaced parts.
Observe all environment protection regula-
tions.
Conduct in events of emergency
Use the middle rear cabin window as emergency
exit!
Loading the machine
During demonstration and when loading the ma-
chine do not remain in the danger zone of the ma-
chine.
Use only stable loading ramps of sufficient load
bearing capacity.
Make sure that persons are not endangered by the
machine tipping or sliding off.
Always switch the rotor off.
Always turn the rotary switch to transport range "I"
to drive the machine onto the transport vehicle.
Lash the machine down, so that it is secured
against rolling, sliding and turning over.
Always use shackles on the lifting points for load-
ing or tying the machine down.
Check all lifting and lashing points for damage be-
fore lashing down the machine.