Dynapac PL 500/20 S, Operation & Maintenance Manual

Page: 37 / 234

C 5
C PL5
00/
20S.
G
B
5-
8 -
04.
07
5 Loading by crane
In the event of breakdown, should it no longer be possible for the machine to be towed
or if it cannot be loaded in any other way, there is also the possibility of raising it by
crane.
$
Use only lifting gear that can bear the load.
(For weights and dimensions, refer to Chapter B). Ensure that the steel cables,
shackles and crosshead are large enough.
Four attachment points (1,2) are
provided on the machine frame
for loading the vehicle using lifting
gear.
- Secure vehicle wherever it is
parked up.
- Store loose parts and accesso-
ries, e.g. lamp fittings, in a safe
place.
- Attach lifting gear to the four at-
tachment points (1, 2).
$
During transport, ensure that the
machine is always horizontal!
Ensure that there is nobody in the danger area.
$
Note cable routing!
If necessary, fit a crosshead or a spacer to prevent damage to the water tank.
$
The chains or steel cables to the
front and rear lift eyes must be ar-
ranged at a relative angle of ap-
prox. 75°! The rear cable must be
at no more than a 30°angle away
from the perpendicular! Danger of
accidents if this is not done!
Side500_compl.wmf
2 1
Side500_compl.wmf
approx. 75°!!
max 30°!!