Dynapac PL 500/20 S, Operation & Maintenance Manual

Page: 205 / 234

F 45
F PL
500/
20S.
G
B 45
-74
- 04.
07
3.6 Water system
Water tank
Check the water tank level before start-
ing work by inspecting the filler gauge (1)
on the right-hand side of the water tank.
If necessary, top up the tank.
- Unscrew filler aperture (2), fill with wa-
ter to top edge then close aperture
properly.
$
If necessary, and at least every 500 op-
erating hours, the inside of the tank
needs to be cleaned. Clean the water
tank as thoroughly as possible once it is
empty.
Spray out the tank as thoroughly as pos-
sible with a water jet lance which can be
inserted into the tank through the filler
aperture.
If the machine is not operating continuously, this water should be changed once a
year.
- Unscrew and remove screw cap (3),
open drain cock (4) and completely
drain the tank.
- Close drain cock (4) again and fit
cap (3).
This water is definitely not drinking qual-
ity!
$
In case of frost, completely empty the
water tank using the drainage valve,
loosen the connection hoses and let
them run empty. Remove screw cap
from water filler apertures.
WTank_Pl500.eps
2
1
Batterie_PL500_V2.wmf
4
3
5