Dynapac PL 500/20 S, Operation & Maintenance Manual

Page: 148 / 234

D 108
D
PL5
00/
20S.
G
B 108
-1
16 -
04.
07
Error
code
and
warn-
ing
lamp
PID(P)
SID(S)
FMI
SPN(S)
FMI Cause Effect
264
YEL-
LOW
P174
2 174
2
Short circuit or undervoltage detect-
ed in fuel temperature sensor circuit
in controller of pump VP44.
Specified value for fuel temperature.
Possibly low power.
278*
YEL-
LOW
P073
11 1075
11
Fault detected in delivery pump elec-
trical circuit on pin 11 of the engine
wiring harness. Possibly low power, engine may stall/
cut out or run roughly or be difficult to
start.
283
YEL-
LOW
P021
3 636
3
Short circuit detected on pin 8 of en-
gine wiring harness for power supply
to main engine speed / position sen-
sor.
ECM uses speed of pump VP44 as a
reserve. Possibly white smoke and loss
of power.
284
YEL-
LOW
P021
4 636
4
Undervoltage detected on pin 8 of
engine wiring harness for power sup-
ply to main engine speed / position
sensor.
ECM uses speed of pump VP44 as a
reserve. Possibly white smoke and loss
of power.
297
YEL-
LOW
P223
3 1084
3
Short circuit detected on pin 48 of
OEM wiring harness for the OEM
pressure signal.
Specified value for OEM pressure.
Loss of ability to control OEM pressure.
298
YEL-
LOW
P223
4 1084
4
Undervoltage detected on pin 48 of
OEM wiring harness for the OEM
pressure signal.
Specified value for OEM pressure.
Loss of ability to control OEM pressure.
319
Mainte-
nance
P251
2 251
2
Power supply to real-time clock was
interrupted and its setting is no long-
er accurate.
The time stamp in the ECM shutdown
data will be incorrect.
349
YEL-
LOW
P191
0 191
0
The auxiliary device speed signal on
pins 8 and 18 of the OEM wiring har-
ness is outside the range of the ECM
threshold values.
Loss of ability to control speed of auxil-
iary unit.
352
YEL-
LOW
S232
4 620
4
Undervoltage detected on pin 10 of
engine wiring harness for +5 V power
supply to engine position sensor.
Specified value for the sensors con-
nected to this +5V power supply. En-
gine is restricted to zero charge fill and
loss of engine protection for oil pres-
sure, intake manifold pressure and am-
bient air pressure.
361
RED S251
3 251
3 High voltage detected on control
valve on fuel pump VP44. Fuel delivery to injector nozzles
blocked and engine shuts down.
362
YEL-
LOW
S251
4 251
4 Undervoltage or no voltage detected
on control valve of fuel pump VP44. Engine loses power and may shut
down.
363
YEL-
LOW
S251
7 251
7
No fuel control valve movement de-
tected from regulator on fuel pump
VP44.
Loss of engine power.
364*
YEL-
LOW
S233
9 1077
9
No data transmission or invalid data
transmission rate detected on data
transfer section between ECM and
regulator on fuel pump VP44 at pins
4 and 13 of engine wiring harness.
Engine runs at a set reserve mode
speed whenever speed adjustment is
not in its idle speed setting.