Dynapac PL 500/20 S, Operation & Maintenance Manual

Page: 7 / 234

3
PL5
00/
16S.
G
B 3-
6 -
06.
05
6.5 Actual value calibration ............................................................................ 73
Digi-Slope sensor (lateral slope sensor) .............................................. 73
Initial situation for actual value calibration ........................................... 73
Other tasks .......................................................................................... 73
Height sensors (to correct the actual value to the value displayed) .... 75
7 Operation ................................................................................................. 76
7.1 Preparing for operation ............................................................................ 76
Devices and aids ................................................................................. 76
Before starting work ............................................................................. 76
Checklist for machine operator ............................................................ 77
7.2 Starting the machine ................................................................................ 79
Auxiliary starting (electrical starting aid) .............................................. 81
............................................................................................................. 81
Allowing engine to „warm up“ .............................................................. 82
Driving the machine ............................................................................. 83
8 Milling instructions .................................................................................... 84
„Driving“ position .................................................................................. 84
„Milling“ position ................................................................................... 84
Zero setting .......................................................................................... 85
Surface milling ..................................................................................... 85
Milling on edge of road surface or on offsets ....................................... 86
Milling at the curb (with deployed chassis leg) .................................... 86
Milling at the curb (with chassis leg retracted) ..................................... 87
Milling without automatic levelling device ............................................ 89
8.1 Operating the Moba-matic during milling ................................................. 91
Initial situation for operation ................................................................. 91
8.2 Other tasks for adopting the initial position for milling: ............................. 92
Milling with height sensors ................................................................... 92
Milling with height sensors together with the transverse slope sensor 96
Ending the milling operation ................................................................ 98
Parking the machine ............................................................................ 99
Parking the machine for long periods of time .................................... 100
9 Scope for using the small planers .......................................................... 101
Remedying longitudinal and transverse bumps in the road surface .. 101
Remedying cracks ............................................................................. 101
Remedying potholes, frost damage ................................................... 101
Remedying damage to edges and bumps ......................................... 102
Producing adjoining edges ................................................................ 102
Producing slots, joints and cable trenches ........................................ 102
Removing embedded markings ......................................................... 103
Removing road markings ................................................................... 103
Re-establishing surface grip .............................................................. 103
10 Malfunctions ........................................................................................... 104
10.1 Error code retrieval for engine ............................................................... 104
Output of numerical code ................................................................... 104
Error codes ........................................................................................ 106
10.2 Error messages for anti-slip control ....................................................... 114
10.3 Travel drive error message ................................................................... 115
10.4 MOBA-Matic error messages ................................................................. 116