Dynapac PL 500/20 S, Operation & Maintenance Manual

Page: 207 / 234

F 47
F PL
500/
20S.
G
B 47
-74
- 04.
07
Water filter
$
Replace the filter cartridge daily after
work, and whenever the contamination
indicator shows that this is necessary!
The machine’s accessories include an-
other water filter to daily replacement is
not a time-consuming operation.
The water filter is located behind the
front flap.
The filter can be changed even if the wa-
ter tank has not been drained.
- Close the stop cock (1).
- Unfasten filter housing (2) using the
wrench in the on-board toolkit and un-
screw by hand.
- Remove filter cartridge (3), also rinse
out housing and install a new / cleaned
filter.
- Clean the locating faces of upper and
lower housing sections and check the
gasket.
- Screw down filter housing by hand
and tighten gently using the wrench.
$
Ensure seal integrity is good after
changing the filter.
- Mesh size of main filter: 75 microns
The removed filter cartridge can be cleaned and, if necessary, can be flushed using
a high-pressure cleaner. After the next time the machine is used, the cleaned filter kit
is then available to replace the other filter.
Absperr.wmf/Batterie_Pl500.tifWasserfilter2_single.tif
1
2
3