Dynapac PL 500/20 S, Operation & Maintenance Manual

Page: 63 / 234

D 23
D
PL5
00/
20S.
G
B 23-
1
16 -
04.
07
Item Designation Brief description
48
Warning lamp
„water in fuel“
(yellow)
Lights up if too much water is detected in the water
separator on the fuel system.
$
To avoid damaging the engine, drain off the
separated water immediately as described in
the Maintenance Instructions.
Lights up for a few seconds once the ignition
has been switched on for checking purposes.
$
Do not start the engine until this indicator lamp
has gone out.
49
Anti-slip
control
(ASC)
Indicator lamp for ASC
-
Continuous light indicates that the anti-slip control
is active.
- If there is a fault in the anti-slip control unit, a flash
code is issued.
Refer to Malfunctions section
50 Steering aid
Always lights up when the steering system is in straight
ahead position as well as during steering movements
with the differential lock activated.
51
Error check
Travel drive (red)
If a fault occurs in the travel drive control system, a
flash code is issued.
Refer to Malfunctions section
52
Hydraulic filter-
Indicator (yellow)
Lights up if ever hydraulic filter needs replacing.
Replace filter cartridge acc. to Maintenance In-
structions!
53
Battery charge
check (red) Must go out after starting when the engine revs up.
-
If this light fails to go out, switch off the engine.
54
Fault / trouble-
shooting query
If a fault discovered on the engine is indicated by one
of the warning lamps, a code is displayed which corre-
lates with a defined defect.
Press the button until this 3-digit code is indicated by
the warning lamp.
Refer to „Malfunctions“ section for details of er-
ror code query procedure!