Dynapac PL 500/20 S, Operation & Maintenance Manual

Page: 162 / 234

F 2
F PL
500/
20S.
G
B 2-
74
-
04.
07
Avoid electric welding work on the machine because this can lead to damage to elec-
tronic and hydraulic assemblies!
In exceptional circumstances, if electric welding work is required on the machine, al-
ways take due note of the following before starting work:
- ignition must be switched off
- interrupt the electrical circuit
- fit earth/ground terminal of welding unit as close as possible to welding location.
Whenever you work on the electrical system, always disconnect the earth/ground ca-
ble from the battery.
Only use fuses with the specified ratings.
2 Liability is rendered null and void if non-genuine spares or wearing parts or in-
correct fuel substances are used.
For maintenance and repair work, only use wearing parts and spare parts approved
by the manufacturer and fit them properly.
In cases of doubt, consult the manufacturer.
Only use substances recommended in these Operating Instructions as lubrication
agents and fuel substances.
Failure to comply with these regulations excludes all manufacturer’s liability for any
resultant damage.
3 Maintenance intervals
The manufacturer is incorporating an ever increasing number of zero-maintenance
assemblies in the design of this machinery. The number of lubricating points de-
scribed in the next section may therefore differ from the actual number of lubricating
points present on the machine.
$
As well as this maintenance manual, always also pay close attention to the mainte-
nance manual provided by the engine manufacturer. All maintenance work and serv-
ice intervals itemised here are binding in nature.