Dynapac PL 500/20 S, Operation & Maintenance Manual

Page: 171 / 234

F 11
F PL
500/
20S.
G
B 1
1
-74
-
04.
07
Oil changes
An oil drain cock is located on the right-
hand side of the machine on the frame.
Risk of scalding from hot oil!
Collect used oil in a suitable container
and dispose of correctly
Before changing the oil, run the engine
up to operating temperature.
- Twist and turn screw cap to remove.
- Fit the hose provided in the accesso-
ries kit. Hold the end of the hose down
in the waste oil container.
- Open the shut-off valve with a wrench and completely drain the oil.
- Close the shut-off valve properly and reinstall the screw cap.
Fill new oil through the filler neck (behind the left-hand flap on the engine compart-
ment).
Check fill level using dipstick (behind the left-hand flap of the engine compartment).
Before checking the oil level with the dipstick, wait for a moment to allow the filled oil
to reach the oil pan.
Follow advice in the Operating instructions for the engine!
Oil filter
$
Change the oil filter at the same time as
each oil change, at intervals of 250 oper-
ating hours.
The oil filter is located on the engine
block behind the right-hand flap of the
en gi n e c o mp ar tm en t . Thi s f l ap i s
opened using a square-section wrench.
Unfasten filter and clean the supporting
surface. Apply light coating of oil to the
gasket on the new filter and fill filter with
oil before installing it. Tighten down by
hand.
Send used filter for proper disposal.
$
After replacing the oil filter, ensure seal integrity and oil pressure are correct.
Follow advice in the Operating instructions for the engine!
Ölablass_PL600.tif
Ölfil_PL500.eps