Dynapac PL 500/20 S, Operation & Maintenance Manual

Page: 45 / 234

D 5
D
PL5
00/
20S.
G
B 5-
1
16 -
04.
07
Item Designation Brief description
4 Steering wheel
Steering action is transmitted hydraulically to the front
wheel or wheels.
To allow for safe handling, the steering wheel is
equipped with a steering knob.
5 Ignition lock
Switch positions:
-
P: Active li hazard flasher can be engaged
- 0: Ignition OFF
- 1: Ignition ON
- 2: Starter function
It is only possible to start the engine if the drive
lever is in centre position, the milling drum is not
engaged and the switches for raising and lower-
ing the machine are in neutral position.
$
The engine cannot be started until all the indica-
tor lamps have gone out.
Key can only be removed from ignition lock in
positions P and 0.
6
7 Multifunction
switch
Integrated flasher switch and switch for high-beam and
low-beam lighting, and horn button (7).
-
Use turn signals (flashers) to change direction of
travel on roads.
- High-beam headlights are switched on by pulling
the lever fully upwards. To switch back to low-
beam headlights, press the lever back down into
centre position.
8
EMERGENCY
STOP button
In the case of an emergency (danger to persons, pos-
sible collision etc.), press in the button!
- The engine, drive units and steering are disengaged
whenever the EMERGENCY STOP button is
pressed.
To restart the engine, all EMERGENCY STOP but-
tons must be raised.
The traction unit brakes are applied whenever
an emergency stop button is pressed!
9
High beam indi-
cator (blue)
Lights up whenever high-beam is switched on (on igni-
tion lock).
Avoid blinding the oncoming traffic!
10
Direction of trav-
el indicator telltale Flashes whenever direction of travel indicator is acti-
vated.