Docomo FOMA D901i, Manual

Page: 167 / 596

165
Safe
ty set
ting
s
4
Press
p
.
The operating conditions of Remote Lock are set.
Setting Remote Lock
Remote Lock is activated by making a call to FOMA terminal under the conditions set in Remote Lock.
･
To perform Remote Lock, send your caller ID and make a call to that number.
･
Remote Lock cannot be activated from a location outside the service area, where radio waves are
hard to reach or when FOMA terminal is not powered ON.
1
Make a voice call to FOMA terminal under the conditions set by Remote Lock.
The guidance that All Lock is set by Remote Lock is played and All Lock is set.
■
Deactivating Remote Lock
To release Remote Lock of FOMA terminal that All Lock is set by Remote Lock, release All
Lock by FOMA terminal that Remote Lock is set.
☛
P158
INFORMATION
●
If registered the phonebook data that the pause and timed pause has been set to the sender’s
information, the information registered after the pause and timed pause is deleted.
●
Auto Lock can be activated by FOMA terminal.
☛
P158
INFORMATION
● When you make a voice call to activate Remote Lock, in case the other party responds to your call, it is
not counted as an incoming call for configuration; Remote Lock cannot be activated. The count is reset to
zero.
● When there is an incoming call from the phone number of the sender registered in Remote Lock while
Answer Machine or Auto Answer is set, Answer Machine or Auto Answer starts in 4 seconds after the
response time set by Answer Machine or Greeting Response Time set by Auto Answer has elapsed.
Terminate the call before Answer Machine or Auto Answer starts. If Answer Machine or Auto Answer has
started, the call is not counted as an incoming call for setting and Remote Lock cannot be activated.
● The count of incoming calls is only effective for the first call made from a sender. After the counting has
been initiated, additional received calls from other senders are not counted.
● Even if a call is rejected, or Voice Mail Service or Call Forwarding Service is used (excluding when the
call time is 0 second), that number is counted as an incoming call.
● When the period from the time counting is initiated until the time limit ends, counting is released, and the
number of missed calls counted from the time counting was initiated is reset to zero.
● If the terminal is turned OFF after the counting has been initiated, the numbers of incoming call that have
been counted will be reset to zero.
● If there is an incoming call from the phone number of the sender registered while Remote Lock is ON, the
receiver hears a guidance that the terminal is on All Lock. If a call arrives from numbers that are not set
as Sender, the call will be disconnected.
● The phone number “186 ( 31#)”/“184 (#31#)” that has been set for the sender does not need to be set
as “186 ( 31#)”/“184 (#31#)” when dialing.
● There is no counting initiated during a call.