Docomo FOMA D901i, Manual

Page: 480 / 596

478
Data Co
mm
unic
a
tio
n
Flow of setup for data communication
This section describes the setup work needed to
connect FOMA terminal to a PC to perform
packet communication or 64K data
communication.
An overview of the steps is given as follows:
Communication configuration file (driver)
Install the communication configuration file on a PC
before connecting FOMA terminal to PC to perform
data communication in the communication mode.
FOMA PC configuration software
When the FOMA PC configuration software (found
on the CD-ROM) is installed on the PC, a number of
settings required for data communication via
connection between FOMA terminal and PC can be
set from PC by simple operation.
Checking operating environment
Use the communication configuration file and the
FOMA PC configuration software in the following
operating environments.
･
Note that utilization may not be possible in certain
operating environments. Furthermore, operation
will not be guaranteed in an environment other
than that described below nor DoCoMo assumes
responsibility for pertaining to operation under
such conditions.
●
W-CDMA
W-CDMA is a third generation communication
system (IMT-2000) and an international
communication standard. FOMA terminal
conforms to the W-CDMA standard.
●
W-TCP
A TCP parameter designed to fully utilize TCP/
IP transmission capacity during packet
communications in a FOMA network. This
communication setting is essential to enable full
use of FOMA terminal capability.
● Administrator privilege
A user level that provides complete access to all
operating system functions in Windows XP and
Windows 2000. There must be at least one user
that has administrator privileges for each PC. A
user that has no administrator privileges is not
normally allowed to install drivers.
Installing communication configuration file
☛
P480
Connecting PC to FOMA terminal
☛
P479
Checking communication configuration file
☛
P481
Installing FOMA PC configuration
software
☛
P483
Setting packet
communication by
easy setup
● mopera
☛
P484
● Other communication
provider
☛
P485
Setting 64K data
by easy setup
● mopera
☛
P487
● Other
communication
provider
☛
P487
Executing communication
☛
P488
(Disconnecting
☛
P489)
Setting up communications without
using FOMA PC configuration software
☛
P492
Connecting
☛
P501
(Disconnecting
☛
P502)
Note: The miniSD memory card is not included in the bundle and needs to be purchased.
☛
P387