Docomo F-08A, Manual

Page: 113 / 462

111
Security Settings
✔
INFORMATION
･
When Lock on close/Lock when immobile is "ON", Lock on close/Lock when immobile
is activated after the power is turned OFF and ON. Lock on close/Lock when immobile
is activated after Omakase Lock is canceled if active.
･
If Lock on close is already activated, Lock when immobile is not activated even if it is
set. Also, if Lock when immobile is already activated, Lock on close is not activated
even if it is set.
◆ Indicating activation of lock with light <Security
indicator>
You can set whether the state of Lock on close/Lock when immobile is shown with
a light.
1
m
[Settings & NW services]
43 e
Authenticate
e 1
or
2
❖
When security indicator is set
If FOMA terminal is closed and Lock on close is activated, the light blinks in blue for
approximately 3 seconds. When set to other than "Right after", if the specified time
elapses, the light blinks in blue for approximately 3 seconds to indicate that Lock on
close/Lock when immobile is activated. Note that, when the light blinks in red for
approximately 3 seconds, it indicates that Lock on close/Lock when immobile is not
activated.
Restricting outgoing/incoming calls and messages
Accepting/Rejecting calls from specified phone
numbers
Accepting/Rejecting incoming call can be set for each phone number saved in
FOMA terminal phonebook.
･
To use this function, specifying Accept/Reject call for each phone number and
Specified caller setting are required. The settings and the operations of Accept/
Reject call are as follows.
* The call from a specified phone number is disconnected with no ring alert and the caller hears a busy
tone.
･
This function is activated only when the other party sends caller ID.
･
Rejected calls are recorded as missed calls.
･
If Ring time is set to "0 Sec." for Voice Mail or Call forwarding, Voice Mail or Call
forwarding is activated and the call is not stored as a received call.
･
Combination of Caller ID Request Service and Anonymous caller is recommended
when used.
◆ Specifying phone numbers to accept/reject calls
<Accept/Reject call>
Accepting/Rejecting incoming call is set for phone numbers saved in FOMA
terminal phonebook.
1
d e
Search the phonebook
e
Move the cursor to a phonebook
entry
e m343 e
Authenticate
e
Select a phone
number
e 1
-
3
･
To accept/reject calls from specified phone numbers, activate settings of
Specified caller in succession to the above step.
･
If a phone number with Accept/Reject call set is edited or deleted, this setting
is canceled. Set Accept/Reject call again for the new number.
◆ Enabling Accept/Reject call from specified numbers
<Specified caller>
･
This setting applies to all phone numbers with Accept/Reject call set.
･
Reject call and Accept call are not enabled simultaneously.
Setting
Accept/Reject call for each phone number
Accept call Reject call No setting
Specified caller Cancel settings Accepted Accepted Accepted
Reject call Accepted Rejected
*
Accepted
Accept call Accepted Rejected
*
Rejected
*