Docomo F-08A, Manual

Page: 55 / 462

53
Voice/Videophone Calls
- Set Caller ID to ON : Caller ID is not sent (such as when connecting to visualnet)
- Redial using voice call : The other party is set for Call Forwarding Service but forwarding
destination does not support videophone calls
- Busy with packet transmission. : The other party is performing packet transmission
- Make call from i-mode web page : You are not making videophone call after connecting to site
provided by IP (Information Provider)
- Upper limit exceeded. Connection failed. : Upper limit of a charging plan with a limiting
function (Type Limit or Family Wide Limit) is exceeded
･
If a videophone call accompanied with Chaku-moji is made when Auto redial as voice
in Operation is set to "ON", Chaku-moji accompanies when redialing.
･
Any videophone call from FOMA terminal to emergency call (110, 119 or 118) with Auto
redial as voice in Operation set to "ON" is automatically switched to a voice call.
･
The speakerphone function switches according to Speakerphone in Operation.
◆ On hold
･
The caller is charged for time spent on hold.
1
During a call,
g
The call is put on hold, light blinks in green, and a melody is played. For a
videophone call, the videophone on-hold image is displayed on the phone of
the other party and yourself.
･
To clear voice call on hold, press
g
or
n
.
･
To clear videophone call on hold, perform any of the following operations.
g
: Redisplay the image sent before the call is put on hold
I
/
n
: Camera image is sent
a
: Substitute image is sent
･
While on hold, FOMA terminal vibrates every 3 minutes, up to 5 times.
However, it does not vibrate in Public mode (Drive mode) or while Vibrate
alert in Personalized silent mode is set to "OFF".
◆ Using speakerphone function
1
Enter a phone number
e n
(1 sec. or more) or
C
appears at the top of the display.
･
For operating from phonebook, Redial, Received calls, Recorded messages or
Voice memos, press
n
(1sec. or more) or
I
.
･
Press
C
for 1 second or more to use speakerphone while Speakerphone in
Operation is set to "OFF".
･
While making a call, ringing or talking on the phone, you can switch the
speakerphone function ON/OFF each time you press
n
.
✔
INFORMATION
･
If you switch to speakerphone, the volume may suddenly increase. Use it with FOMA
terminal away from your ears.
･
Talk to FOMA terminal within approximately 50 cm. If a call is hard to hear from the
speaker due to loud noise around you or the other party, turn the speakerphone
function OFF.
･
This function can be used in Silent mode.
◆
Adjusting Listen volume during a call
･
This setting applies to Listen volume in Adjust volume.
･
Volume of the speakerphone function is retained even after a call but not applied
to Listen volume.
1
During a call,
j
◆
Using Voice clear/Voice slowing
❖
Switching Voice clear ON/OFF
This function detects ambient noise and optimizes the other party's voice during a
voice call by limited vocal range to make the voice be heard clearly. And, the volume
is automatically increased also when your or other party's voice is small.
･
This function does not operate while using speakerphone function or in overseas
GSM/GPRS network.
･
The settings are retained after a call.
･
This function is not for adjusting Listen volume. Change the volume of the other
party's voice with Listen volume.
1
During a voice call,
m7
When setting to "ON", appears. When this does not operate with
ON, it is displayed in gray.