System Test Monitor
Running the
System Test
This section describes the test command interface to use to run
the system test on a device or on the whole system. Table 5–8
shows the general format for running the system test with the
test command.
Table 5–8 Running the System Test Using the Test Command
Command
Action
T 100
Runs system test in the customer environment for
two passes.
T 101
Runs system test in the Digital Services
environment for two passes.
T 102
Runs system test in the Digital Services
environment. Press
Ctrl C
to exit.
T 103
1
Runs system test in the manufacturing
environment. Press
Ctrl C
to exit.
T 106
Runs system test for specific devices. System
prompts for specific device. 1=Yes, 0=No.
1
This test writes over data on hard disks. Do not use in the customer
system; it erases customer data.
NOTE
Ensure that loopback connectors are installed while in
the Digital Services environment. SET DIAGENV 2 to
run in Digital Services mode. (Table 4–2 and Table 5–3
contain descriptions and commands for the diagnostic
environments.)
Examples:
The following examples show the response to system test
commands.
Continued on next page
5–32
