Module Removal,
Continued
MS44 Memory
Module
Replacement
To install a new MS44 memory module, perform the following
steps.
NOTE
When installing memory modules (sets of four), each
set must be installed in the slots identified for a
particular set. These designators are to the right of
each slot and identified with a 0x (where x=A1x [where
x=E,F,G,H] for set 1.
Step
Action
1
Look for the double grove at end of the SIM module
connector.
2
Install the module with the grove towards the right side
of CPU module, looking from the front.
3
Start with the rear-most connector.
4
Place the memory module in the connector and tilt the
module approximately 55 degrees forward. Make sure
the double notched lower corner of the memory module is
away from the power supply.
5
Pivot the memory module upward until the metal tabs
connect with the memory module.
Graphics
Module
Removal
The SPXg 8-plane or SPXgt 24-plane graphics module is located
towards the rear of the system box, next to the power supply.
Figure 6–1 shows its location in the system box. To remove these
modules from the system box, use the procedures described next.
6–27
