SPXg 8-Plane Option,
Continued
6
See Figure 6–14. Carefully
tilt the assembly into
position
!
.
The two hooks on the system box subchassis slip
through the square holes in the lower curve of
the connector bracket.
7
Insert the assembly.
With the assembly in position, align the graphics
subsystem processor and system module inter-
module connectors
"
. Mate the connectors by
pressing down on the frame buffer module above
the inter-module connectors. The board latches
should snap into place to secure the 3D graphics
option assembly.
The bottom surface of the connector bracket
sits on the subchassis, held in place by the
hooks and the square ridge on the subchassis.
Figure 6–13 is a detailed side view.
Figure 6–12 Switch 2 Position
WMO_SPXGGT_008
Rocker Switch
Slide Switch
Switch 2
Position
Switch 2
Position
Continued on next page
6–31
