Module Removal,
Continued
NOTE
Memory modules must always be removed starting
from the front of the system. For example, to replace
the module at the rear of the system board, you must
remove any modules at the front of the board and
work toward the rear. Memory module locations are
numbered on the right edge of the memory connectors
located on the system board.
The location of the memory modules is shown in Figure 6–1.
To remove the MS44 memory modules, perform the following
steps:
Step
Action
1
Remove the hard disk drive.
2
Starting with the forward-most module, release the
two metal retainers at each end of the memory module
connector.
3
Rotate the module forward approximately 55 degrees to
the front of the unit and lift it out of the slot.
CAUTION Failure to release the two module retainers
will permanently damage the module connector located
on the system board.
Continued on next page
6–26
