Digital Equipment DEC 3000 600 AXP, Service Information

Page: 412 / 461

SCSI Diagnostic Status/Error Messages
Information Description
03 Interrupt bit clear in Control Status register.
04 Bus service bit clear in Control Status register.
05 Disconnect bit clear in Control Interrupt
register.
06 Disconnect bit set in Control Interrupt register.
07 Illegal command bit clear in Control Interrupt
register.
08 Illegal command bit set in Control Interrupt
register.
09 Arbitration not won.
0A Selection timeout.
0B Invalid sequence in Sequence Step register.
0C Unexpected ISR hit.
0D Interrupt service routine was not entered.
0E Interrupt bit in controller status register will
not clear.
0F Bad request sense key.
10 Bad status returned from status phase.
11 Not enough sense data returned from a request
sense command.
12 Phase did not go to command phase.
13 Phase did not go to message out phase.
14 Phase did not go to message in phase.
15 Command phase changed too soon.
16 Message in phase changed too soon.
17 Stuck in command phase.
18 Stuck in message in phase.
19 Stuck in message out phase.
1A Stuck in data out phase.
1B Stuck in data in phase.
1C Should not be in message out phase.
1D No interrupt after sending SCSI command.
1E No interrupt after sending command complete.
1F No interrupt after sending message accepted.
20 No interrupt after sending transfer
information.
21 All data out bytes were not sent.
22 Unexpected message reject from device.
23 FIFO Flag count is wrong.
24 Message is unsupported.
25 Bus device reset was sent, but device did not
drop off bus.
26 Illegal phase.
14–29