Digital Equipment DEC 3000 600 AXP, Service Information

Page: 156 / 461

Overview
General Rules
Before upgrading or replacing storage devices or memory, follow
these general rules:
• If replacing storage devices, then set storage devices to the
same SCSI ID as the previously removed drive.
• If upgrading storage devices, then enter the console command
SHOW CONFIG to see all current SCSI address settings.
• If upgrading or replacing memory, make sure all memory
modules are of same type for each memory bank and that
each bank is fully populated.
Commands Use the following commands to verify compliance with the
general rules and the results of configuration procedures:
• SHOW CONFIGURATION
• SHOW MEMORY
• SHOW DEVICE
7–2