C-10
Service Manual PRELIMINARY
The enable command can fail for the following reasons:
•
No modem access password was set.
•
The initialization string or the answer string might not be set properly. (See
Section C.7.)
•
The modem is not connected or is not working properly.
•
The modem has been disabled from the RCM switchpack. To enable the
modem, reset switch 2 (MODEM OFF) on the switchpack to OFF (enabled).
If the enable command fails, the following message is displayed:
*** ERROR - enable failed ***
hangup
The hangup command terminates the modem session. When this command is
issued, the remote user is disconnected from the server. This command can be
issued from either the local or remote console.
RCM>hangup
halt
The halt command halts the managed system. The halt command is equivalent to
pressing the Halt button on the control panel and then immediately releasing it. The
RCM firmware exits command mode and reconnects the user’s terminal to the
system COM1 serial port.
RCM>halt
Focus returned to COM port
The halt command can be used to force a halt assertion. See Section A.9 for
information on halt assertion.
NOTE: If you are running Windows NT, the halt command has no effect.
