Removal and Replacement
6-29
Removal
1.
Shut down the operating system and power down the system.
2.
Expose the card cage side of the system. See Section 6.3.
3.
To remove the StorageWorks door:
a.
Open the door slightly and grab the left edge of the door with your left hand
and the right edge of the door with you right hand.
b.
While pushing the door up, bend it by pulling it away from the system. The
door compresses enough so it’ bottom post slips out of its retaining hole.
c.
Once the bottom of the door is free, gently pull the top down to release it
from the post on the door jam and release it from the spring.
d.
Put the door aside
4.
Using a Phillips head screwdriver, remove the 9 screws holding the molded
plastic front panel to the system. (Six screws accessed from the front of the
system and three through the fan compartment of the system.)
5.
Tilt the front panel away from the system and disconnect all the cables from the
OCP.
6.
Once the front panel is removed, unscrew the four screws holding the OCP to
the front panel.
Replacement
Reverse the steps in the Removal procedure.
Verification
Power up the system. If the OCP you installed is faulty, the system will not power
up.
