Removal and Replacement
6-37
Removal
1.
Shut down the operating system and power down the system.
2.
Expose the card cage side of the system. See Section 6.3.
3.
Remove the power and signal cables from the repeater on the side of the
StorageWorks shelf.
4.
Remove the power harness and all signal cables from the StorageWorks
backplane.
5.
Using a short Phillips head screwdriver, remove the screws holding the
backplane to the back of the shelf and remove from the system.
Replacement
Reverse the steps in the Removal procedure.
Verification
Power up the system. Use the show device console command to verify that the
StorageWorks shelf is configured into the system.
