C-4
Service Manual PRELIMINARY
C.2.1
Configuring the Modem
The RCM requires a Hayes-compatible modem. The controls that the RCM sends to
the modem are acceptable to a wide selection of modems. After selecting the
modem, connect it and configure it.
Qualified Modems
The modems that have been tested and qualified with this system are:
•
Motorola 3400 Lifestyle 28.8
•
AT&T Dataport 14.4/FAX
•
Hayes Smartmodem Optima 288 V-34/V.FC + FAX
Modem Configuration Procedure
1.
Connect a Hayes-compatible modem to the RCM as shown in Figure C-1, and
power up the modem.
2.
From the local serial console terminal, type the following escape sequence to
invoke the RCM:
P00>>>
^]^]rcm
The character “^” is created by simultaneously holding down the Ctrl key and
pressing the ] key (right square bracket). The SRM prompt, RCM>, is
displayed.
3.
Use the setpass command to set a modem password.
4.
Enable the modem port with the enable command.
5.
Enter the quit command to leave the RCM.
6.
You are now ready to dial in remotely.
