DAP Technology 1394, Operation Manual

Page: 321 / 458

Automotive Multimedia Interface - Collaboration protocol (AMI-C)
321 Copyright © DapTechnology B.V., 2005-2019 - All Rights Reserved., 5/20/2019
It contains the following additional control:
Analyzer node select control
With this control you are able to select the protocol analysis result of each supported Analyzer node.
18.1.2.2. Relations Pane
This pane shows all transactions and packets found, grouped into items and displayed in a tree. The tree
structure indicates the relation between the items. The items are not necessarily recorded in the same
order as displayed in this tree. However, all items inside the same item of the tree (at the same level) are
listed in the same order as the first corresponding packet of each item was recorded. To find out the order
of corresponding transactions and packets, see the 'transactions and packets' pane or take a look at one
of the other views of the Recorder (e.g. the Transactions View).
Inside the Unit items, the following items can displayed:
FCP commands usually consist of a command transaction, followed by a response transaction. Both are
grouped into the 'FCP command' items. See example below.
For each found or manually specified NodeSpec there will be a root item in the tree (NodeSpec 0 above).
For information about NodeSpec's, see 'IP4-Protocol Settings' below. For each found or manually
specified Unit, there will be a Unit item inside the corresponding NodeSpec (Unit 0 in NodeSpec 0
above).
18.1.2.3. Details Pane
The middle part of the Protocol View shows the details of the item that is selected in the 'relations' pane.
An example that shows the details of an 'AMI-C message' item follows:
When selecting a transaction in the 'Transactions and packets' pane, the details of that transaction are
listed this pane. You can choose between a Field view or a Layout view.
We will describe the different parts below: