DAP Technology 1394, Operation Manual

Page: 277 / 458

Industrial / Instrumentation Digital Camera protocol (IIDC)
277 Copyright © DapTechnology B.V., 2005-2019 - All Rights Reserved., 5/20/2019
protocol-specific settings. The dialog will be initialized with all information that can be found automatically.
If this is not enough for a correct analysis (e.g. the IIDC unit's base command address was not recorded),
you can add this information manually. An example of the dialog is shown below.
In the dialog you see an upper part to specify one or more 'Node Specifications', and a lower part to
specify protocol-specific information. In between these two parts, general options can be selected.
For a correct analysis the Unit information of the IIDC device to be analyzed must be present. To be able
to specify a Unit, you will first need to specify the device (Node Specification) the Unit is part of.
For more information about Node Specifications and the protocol independent part of the Protocol
Settings, see
Protocol Settings . For the IIDC protocol specific settings, see below.
Node Specifications
If no IIDC Units were found automatically, you have to specify one or more Units manually. Before you
can specify a Unit you have to specify the node the Unit is part of, using a Node Specification. When the
IIDC device is still connected to the bus after recording, you can use the 'Search Current' button to
automatically find IIDC Units. Adding such a Unit will create a Node Specification and Unit. The created
Node Specification will be filled automatically when possible. You probably will have to select correct
nodes for some reset segments. Make sure you have selected the IIDC node corrrectly for those reset
segments for which transaction and packets are recorded that you want to analyze. For more information
on Node Specifications, see
Protocol Settings .
General options
Mark unhandled packets
For information about this checkbox, please see
Protocol Settings .
Protocol-specific information