DAP Technology 1394, Operation Manual

Page: 308 / 458

Serial Bus Protocol (SBP)
308 Copyright © DapTechnology B.V., 2005-2019 - All Rights Reserved., 5/20/2019
Without the option checked (example above), all the fields of the item are listed, including the
command-set-specific part ('command block' in the example above). Note however, that the
command-set-specific part is not formatted in this case. It is just the SBP definition of the ORB block.
When the 'show command-set-specific format' option is selected, only the command-set-specific part is
displayed. In the example above, the same item is selected, but now only the 'command block' is shown.
It is formatted according to the format set defined in the SBP-Protocol Settings (see below). The used
command set is also shown after the check box. In the example above it is the SCSI-Direct-access (SBC)
command set.
Fields
The 'Fields' table shows the fields that are defined for the selected item and the corresponding values of
these fields.
When a part of the item contains command-set-specific information, the user has the option to show all
the item fields (including the unformatted command data) or only the command data formatted
corresponding to the defined command set. See 'show command-set-specific format .' above.
If the selected item consists of more then one transaction and one of these transactions is selected (in the
'transactions and packets' pane for instance), the fields corresponding to that transaction are highlighted.
In the example below, the selected item consists of 8 transactions and the third transaction of the item
was selected, which happens to correspond to the fields of the third table segment.
Layout
The 'Layout' shows the layout of the selected item. Like the 'Fields' table it shows the fields that are