D-Link DWS-4000 Series, Cli Command Reference

Page: 383 / 566

375
Quality of Service Commands
S e c t i o n 7 : Q u a l i t y o f S e r v i c e C o m m a n d s
This section describes the Quality of Service (QoS) commands available in the Unified Switch CLI.
The QoS Commands section contains the following subsections:
• “Class of Service Commands” on page 375
• “Differentiated Services Commands” on page 381
• “DiffServ Class Commands” on page 382
• “DiffServ Policy Commands” on page 387
• “DiffServ Service Commands” on page 390
• “DiffServ Show Commands” on page 391
• “MAC Access Control List Commands” on page 397
• “IP Access Control List Commands” on page 400
• “Auto-Voice over IP Commands” on page 406
C
LASS OF
S
ERVICE
C
OMMANDS
This section describes the commands you use to configure and view Class of Service (CoS) settings for the switch. The
commands in this section allow you to control the priority and transmission rate of traffic.
classofservice dot1p-mapping
This command maps an 802.1p priority to an internal traffic class. The
<userpriority>
values can range from 0-7. The
<trafficclass>
values range from 0-6, although the actual number of available traffic classes depends on the platform.
For more information about 802.1p priority, see “Voice VLAN Commands” on page 45
.
Note: The commands in this section are in one of two functional groups:
• Show commands display switch settings, statistics, and other information.
• Configuration commands configure features and options of the switch. For every configuration command,
there is a show command that displays the configuration setting.
Note: Commands you issue in the Interface Config mode only affect a single interface. Commands you issue in
the Global Config mode affect all interfaces.
Format
classofservice dot1p-mapping <userpriority> <trafficclass>
Modes • Global Config
• Interface Config