D-Link DWS-4000 Series, Cli Command Reference

Page: 542 / 566

D-Link Unified Switch CLI Command Reference
534
© 2009 D-Link Corporation. All Rights Reserved
T
ECHNOLOGIES
Table 49: ARP Log Message
Component Message Cause
ARP ARP received mapping for IP address xxx to MAC
address yyy. This IP address may be configured on
two stations. When we receive an ARP response with different
MAC address from another station with the same
IP address as ours. This might be a case of
misconfiguration.
Table 50: RIP Log Message
Component Message Cause
RIP RIP : discard response from xxx via unexpected
interface When RIP response is received with a source
address not matching the incoming interface’s
subnet.
Table 51: Driver Error Messages
Component Message Cause
Driver Invalid USP unit = x, slot = x, port = x A port was not able to be translated correctly
during the receive.
Driver In hapiBroadSystemMacAddress call to
'bcm_l2_addr_add' - FAILED : x Failed to add an L2 address to the MAC table. This
should only happen when a hash collision occurs
or the table is full.
Driver Failed installing mirror action - rest of the policy
applied successfully A previously configured probe port is not being
used in the policy. The release notes state that
only a single probe port can be configured.
Driver Policy x does not contain rule x The rule was not added to the policy due to a
discrepancy in the rule count for this specific policy.
Additionally, the message can be displayed when
an old rule is being modified, but the old rule is not
in the policy.
Driver ERROR: policy x, tmpPolicy x, size x, data x x x x
x x x x An issue installing the policy due to a possible
duplicate hash.
Driver ACL x not found in internal table Attempting to delete a non-existent ACL.
Driver ACL internal table overflow Attempting to add an ACL to a full table.
Driver In hapiBroadQosCosQueueConfig, Failed to
configure minimum bandwidth. Available
bandwidth x Attempting to configure the bandwidth beyond it’s
capabilities.
Driver USL: failed to put sync response on queue A response to a sync request was not enqueued.
This could indicate that a previous sync request
was received after it was timed out.
Driver USL: failed to sync ipmc table on unit = x Either the transport failed or the message was
dropped.
Driver usl_task_ipmc_msg_send(): failed to send with x Either the transport failed or the message was
dropped.