D-Link DWS-4000 Series, Cli Command Reference

Page: 294 / 566

D-Link Unified Switch CLI Command Reference
286
© 2009 D-Link Corporation. All Rights Reserved
A
CCESS
P
OINT
P
ROFILE
VAP C
OMMANDS
The commands in this section provide Virtual Access Point (VAP) configuration per radio interface within an access point
profile.
vap
This command enters the AP Profile VAP configuration mode. In this mode you can modify the VAP configuration parameters
of the selected AP profile.
enable (AP Profile VAP Config Mode)
This command enables the configured VAP on the radio. VAP0 cannot be disabled; if you want to disable VAP0, you must
turn off the radio.
no enable
The
no
version of this command disables the configured VAP on the radio. This command is not valid for VAP 0.
network (AP Profile VAP Config Mode)
This command configures the network to apply to the VAP. A VAP must be configured with a network; therefore the network
cannot be deleted.
Format
vap <0-15>
Mode AP Profile Radio Config
Parameter Description
0-15 VAP ID
Default VAP 0 - Enable, VAP 1-15 - Disable
Format
enable
Mode AP Profile VAP Config
Format
no enable
Mode AP Profile VAP Config
Default The default networks 1-16 are applied to VAP0 – VAP15 in order.
Format
network <1-64>
Mode AP Profile VAP Config
Parameter Description
1-64 A configured network ID.