D-Link DWS-4000 Series, Cli Command Reference

Page: 257 / 566

249
Wireless Network Commands
no wep authentication
The
no
version of this command sets WEP authentication mode to the default value, which is open system .
wep key
This command configures up to 4 static WEP keys for the network. The configured keys are used when the network security
mode is set to WEP shared key, according to the configured WEP transfer key index. The number of characters required
depends on the configured WEP key type and length.
no wep key
The
no
version of this command removes the corresponding WEP key configuration.
wep tx-key
This command configures the WEP key index to be used for encryption on the network. This value is applicable only when
the security mode is configured for WEP shared key authentication and encryption.
Default Open System
Format
wep authentication {open-system [shared-key] | shared-key}
Mode Network Config
Parameter Description
open system No authentication required.
shared-key Clients are required to authenticate to the network using a shared key.
Format
no wep authentication
Mode Network Config
Format
wep key <1-4> <value>
Mode Network Config
Parameter Description
1-4 A valid WEP key index.
value The WEP key itself, entered in ASCII or HEX format. The following list shows the number of keys to
enter in the field:
• 64 bit —ASCII: 5 characters; Hex: 10 characters
• 128 bit —ASCII: 13 characters; Hex: 26 characters
• 152 bit —ASCII: 16 characters; Hex: 32 characters.
For more information, please see the “Static WEP” table in the Unified Switch Administrator’s Guide.
Format
no wep key <1-4>
Mode Network Config