D-Link DWS-4000 Series, Cli Command Reference

Page: 544 / 566

D-Link Unified Switch CLI Command Reference
536
© 2009 D-Link Corporation. All Rights Reserved
O/S S
UPPORT
Driver USL: failed to sync initiator table on unit = x Could not synchronize unit x due to a transport
failure or API issue on remote unit. A
synchronization retry will be issued.
Driver USL: failed to sync terminator table on unit = x Could not synchronize unit x due to a transport
failure or API issue on remote unit. A
synchronization retry will be issued.
Driver USL: failed to sync ip-multicast table on unit = x Could not synchronize unit x due to a transport
failure or API issue on remote unit. A
synchronization retry will be issued.
Table 52: OSAPI VxWorks Log Messages
Component Message Cause
OSAPI VxWorks ftruncate failed – File resides on a read-only file
system. ftruncate is called to correctly set the file’s size in
the file system after a write. The file system is R/W
so this msg indicates the file system may be
corrupted.
OSAPI VxWorks ftruncate failed – File is open for reading only. ftruncate is called to correctly set the file’s size in
the file system after a write. The file is opened for
R/W so this msg indicates the file system may be
corrupted.
OSAPI VxWorks ftruncate failed – File descriptor refers to a file on
which this operation is impossible. ftruncate is called to correctly set the file’s size in
the file system after a write. This msg indicates the
file system may be corrupted.
OSAPI VxWorks ftruncate failed – Returned an unknown code in
errno. ftruncate is called to correctly set the file’s size in
the file system after a write. This msg indicates the
file system may be corrupted.
OSAPI VxWorks ping: bad host! The address requested to ping can not be
converted to an Internet address.
OSAPI VxWorks osapiTaskDelete: Failed for (XX) error YYY The requested task can not be deleted because:
the requested deletion is called from an ISR, the
task is already deleted, or the task ID is invalid.
OSAPI VxWorks osapiCleanupIf: NetIPGet During the call to remove the interface from the
route table, the attempt to get an ipv4 interface
address from the stack failed.
OSAPI VxWorks osapiCleanupIf: NetMaskGet During the call to remove the interface from the
route table ,the attempt to get the ipv4 interface
mask from the stack failed.
OSAPI VxWorks osapiCleanupIf: NetIpDel During the call to remove the interface from the
route table, the attempt to delete the primary ipv4
address from the stack failed.
OSAPI VxWorks osapiSemaTake failed The requested semaphore can not be taken
because: the call is made from an ISR or the
semaphore ID is invalid.
Table 51: Driver Error Messages (Cont.)
Component Message Cause