D-Link DWS-4000 Series, Cli Command Reference

Page: 200 / 566

D-Link Unified Switch CLI Command Reference
192
© 2009 D-Link Corporation. All Rights Reserved
no default-information originate (RIP)
This command is used to control the advertisement of default routes.
default-metric (RIP)
This command is used to set a default for the metric of distributed routes.
no default-metric (RIP)
This command is used to reset the default metric of distributed routes to its default value.
distance rip
This command sets the route preference value of RIP in the router. Lower route preference values are preferred when
determining the best route. A route with a preference of 255 cannot be used to forward traffic.
no distance rip
This command sets the default route preference value of RIP in the router.
distribute-list out (RIP)
This command is used to specify the access list to filter routes received from the source protocol.
Format
no default-information originate
Mode Router RIP Config
Format
default-metric < 0-15 >
Mode Router RIP Config
Format
no default-metric
Mode Router RIP Config
Default 15
Format
distance rip < 1-255 >
Mode Router RIP Config
Format
no distance rip
Mode Router RIP Config
Default 0
Format
distribute-list <1-199> out {static | connected}
Mode Router RIP Config