D-Link DWS-4000 Series, Cli Command Reference

Page: 339 / 566

331
Detected Clients Database Commands
D
ETECTED
C
LIENTS
D
ATABASE
C
OMMANDS
This section provides status and configuration commands for the detected client database.
wids-security client rogue-det-trap-interval
Use this command to set the interval in seconds between transmissions of the trap telling you that rogue clients are present
in the Detected Clients Database.
no wids-security client rogue-det-trap-interval
Use this command to restore the rogue detection trap interval to its default value, 60.
Example: The following shows an example of the command.
(DWS-4026) # wids-security client rogue-det-trap-interval 60 ?
<cr> Press Enter to execute the command.
(DWS-4026) # no wids-security client rogue-det-trap-interval ?
<cr> Press Enter to execute the command.
wids-security client known-client-database
Use this command to enable the test which marks the client as a rogue if it is not in the Known Clients database.
no wids-security client known-client-database
Use this command to disable the check for the client in the Known Clients database.
Default 60
Format
wids-security client rogue-det-trap-interval <0-3600>
Mode Wireless Config
Parameter Description
0-3600 Interval in seconds between transmissions of the trap. The range is 0-3600 seconds. A configured
value of 0 disables the trap from being sent.
Format
no wids-security client rogue-det-trap-interval
Mode Wireless Config
Default Disable
Format
wids-security client known-client-database
Mode Wireless Config
Format
no wids-security client known-client-database
Mode Wireless Config