D-Link DWS-4000 Series, Cli Command Reference

Page: 102 / 566

D-Link Unified Switch CLI Command Reference
94
© 2009 D-Link Corporation. All Rights Reserved
show port-channel system priority
Use this command to display the port-channel system priority.
P
ORT
M
IRRORING
Port mirroring, which is also known as port monitoring, selects network traffic that you can analyze with a network analyzer,
such as a SwitchProbe device or other Remote Monitoring (RMON) probe.
monitor session
This command configures a probe port and a monitored port for monitor session (port monitoring). Use the
source
interface <slot/port>
parameter to specify the interface to monitor. Use
rx
to monitor only ingress packets, or use
tx
to monitor only egress packets. If you do not specify an
{rx | tx}
option, the destination port monitors both ingress
and egress packets. Use the
destination interface <slot/port>
to specify the interface to receive the monitored
traffic. Use the
mode
parameter to enabled the administrative mode of the session. If enabled, the probe port monitors all
the traffic received and transmitted on the physical monitored port.
no monitor session
Use this command without optional parameters to remove the monitor session (port monitoring) designation from the source
probe port, the destination monitored port and all VLANs. Once the port is removed from the VLAN, you must manually add
the port to any desired VLANs. Use the
source interface <slot/port>
parameter or
destination interface
<slot/port>
to remove the specified interface from the port monitoring session. Use the
mode
parameter to disable the
administrative mode of the session.
no monitor
This command removes all the source ports and a destination port for the and restores the default value for mirroring session
mode for all the configured sessions.
Format
show port-channel system priority
Mode Privileged EXEC
Format
monitor session <session-id> {source interface <slot/port> [{rx | tx}] |
destination interface <slot/port> | mode}
Mode Global Config
Note: Since the current version of Unified Switch software only supports one session, if you do not supply optional
parameters, the behavior of this command is similar to the behavior of the
no monitor
command.
Format
no monitor session <session-id> [{source interface <slot/port> | destination
interface <slot/port> | mode}]
Mode Global Config
Note: This is a stand-alone “no” command. This command does not have a “normal” form.