D-Link DWS-4000 Series, Cli Command Reference

Page: 141 / 566

133
LLDP (802.1AB) Commands
seconds. The
<hold-value>
is the multiplier on the transmit interval that sets the TTL in local data LLDPDUs. The
multiplier range is 2-10. The
<reinit-seconds>
is the delay before re-initialization, and the range is 1-0 seconds.
no lldp timers
Use this command to return any or all timing parameters for local data transmission on ports enabled for LLDP to the default
values.
lldp transmit-tlv
Use this command to specify which optional type length values (TLVs) in the 802.1AB basic management set are transmitted
in the LLDPDUs. Use
sys-name
to transmit the system name TLV. To configure the system name, see “snmp-server” on
page 496 . Use
sys-desc
to transmit the system description TLV. Use
sys-cap
to transmit the system capabilities TLV. Use
port-desc
to transmit the port description TLV. To configure the port description, see See “description” on page 15.
no lldp transmit-tlv
Use this command to remove an optional TLV from the LLDPDUs. Use the command without parameters to remove all
optional TLVs from the LLDPDU.
lldp transmit-mgmt
Use this command to include transmission of the local system management address information in the LLDPDUs.
Default • interval—30 seconds
• hold—4
• reinit—2 seconds
Format
lldp timers [interval <interval-seconds>] [hold <hold-value>] [reinit <reinit-
seconds>
]
Mode Global Config
Format
no lldp timers [interval] [hold] [reinit]
Mode Global Config
Default no optional TLVs are included
Format
lldp transmit-tlv [sys-desc] [sys-name] [sys-cap] [port-desc]
Mode Interface Config
Format
no lldp transmit-tlv [sys-desc] [sys-name] [sys-cap] [port-desc]
Mode Interface Config
Format
lldp transmit-mgmt
Mode Interface Config