D-Link DWS-4000 Series, Cli Command Reference

Page: 224 / 566

D-Link Unified Switch CLI Command Reference
216
© 2009 D-Link Corporation. All Rights Reserved
The following table lists the command parameters
The following table lists the output fields that display.
Example: The following shows example CLI display output for the command.
If a network consists of two switches 192.168.37.60 and 192.168.37.61 respectively and former is the Cluster Controller,
this command works differently at Cluster Controller and peer switch that is not acting as a Cluster Controller as follows.
On the Cluster Controller, it displays entries in the following format:
(DWS-4026) show wireless switch 10.27.65.8 status
Switch IP Address.............................. 10.27.65.8
Cluster Priority............................... 1
Total Access Points............................ 0
Managed Access Points.......................... 0
Connection Failed Access Points................ 0
Discovered Access Points....................... 0
Maximum Managed Access Points.................. 64
Total Clients.................................. 0
Authenticated Clients.......................... 0
Format
show wireless switch <ipaddr> status
Mode Privileged EXEC
Parameter Description
ipaddr IP address of the Unified Switch in the wireless system.
Field Description
Switch IP Address IP address of the Unified Switch or any peer switch in the wireless system.
Cluster Priority Priority of this switch for the Cluster election.
Total Access
Points The total number of access points in the managed AP database. This value is always equal to the sum
of Managed Access Points, Connection Failed Access Points, and Discovered Access Points.
Managed Access
Points The total number of APs in the managed AP database that are authenticated, configured, and have an
active connection with the Unified Switch.
Connection Failed
Access Points The number of APs that were previously authenticated and managed, but lost connection with the
Unified Switch.
Discovered Access
Points APs that have a connection with the Unified Switch, but have not yet been completely configured (i.e.
managed APs with a discovered or authenticated status).
Maximum Managed
Access Points The maximum number of managed access points supported by the switch.
Total Clients Total number of clients in the database. This total includes clients with an Associated, Authenticated,
or Disassociated status.
Authenticated
Clients Total number of clients in the associated client database with an “Authenticated” status.
Distributed Tunnel
Clients Number of clients that are currently sending and receiving packets via distributed tunnels.
WLAN Utilization Total network utilization across all APs managed by this switch, this is an average of the global
statistics received from each AP.